Re-bled the brakes today. Having a pressure bleeder makes the job extremely fast and simple!
Re-bled the brakes today. Having a pressure bleeder makes the job extremely fast and simple!
Main reason for pulling the intake manifold. I think I also had a leak where the intake manifold meets the engine block. Check my build thread. I know my oil /air separator was not working correctly as there is a huge oil stain below it on the block
EDIT: not cold weather, car has been in Socal all its life
^^^ Yup. I wasnt sure I got all the air out the first time. My pedal doesn't feel spongy per say, but the pedal travel takes a little less effort than before. Hopefully that makes sense. My brakes don't feel bad at all, just different from before. They definitely stop me on a dime if I have too, the pedal travel just doesn't seem as firm as before.
I was thinking it could be the combination of the new calipers, lines, rotors and pads. I'm 99 percent sure the lines are all bubble free, the brake reservoir was always filled to the max as well so I'm pretty certain I didn't let any air into the ABS system. The lines were only disconnected for a few seconds each. Any ideas?
Diagnosed my vacuum leak finally! New parts on the way. No wonder power was down and car stalled at idle. Oil and air was leaking at the intake manifold gasket.
What kind of pads did you use? I felt the same affect when I switched to Hawk pads. I had flushed the fluid at the same time and thought I f'd up the procedure. I bled them several additional times and even had the dealer do it to properly modulate the DSC/ABS system but the pedal still felt the same so I gave up. I think it was Vas that experienced the same thing with Hawk? It was in a recent thread
Dinan CAI &Throttle body, ESS Tuning TS2, Bimmerbrakes gen3 headers, UUC SSK & DSSR. Achilles oil pump, VAC oil pan baffle
M3 Motor mounts, UUC Trans mounts, Modified clutch style LSD 3.15, TMS front subframe reinforcement, Koni Yellow sports,
H&R sport springs, UUC sway bars, BMW Perf. Rotors, UUC SS brake lines, Hawk HPS pads, CSL replica wheels,
Rotora strut bar, FXR HID conversion, M3 Mirror conversion, BSW stage 1 speakers